|
Installation
Tips
How
to Make A Patch Lead
- Strip
the cable sheath a min of 20mm from the end of the conductors.
- Sort
the pairs into the correct sequence of how they will be terminated.
- The
normal scheme to use is 568B.
- Trim
the conductors square and to the correct length.
- Insert
the cable into the plug and ensure the conductors are fully under
the pins and the jacket is under the strain relief.
- Crimp
the pins with a modular crimp tool.
- Check
all eight contacts are fully engaged and are slightly below the
plastic channels.
tips@commsplace.com
|
